Hi friends, There is an installation in conference room where I have to program multisensor in all 3 modes i.e for remote sensing, light level maintainance and motion sensing. The exact requirement is as written below. 1. Whenever first person enters the conference room, a preset light group should become ON. It should not sense any further motion until conference room becomes fully vacant and first person enters next time. 2. Scenes will be triggered from the remote. Right now, I have stored scenes on colour C-Touch and I am calling them using action selectors. 8 Action selectors are defined on 8 virtual keys on m'sensor. So this requirement is fulfilled for the time being. 3. Lights near the windows are to be maintained according to the abience light. PROBLEM: If I want to use motion sensing feature along with remote, I am forced to sacrify one of my virtual key, which I don't want. I don't want my running scenes to be overridden by light level or motion sensing. Can you suggest me any good way to overcome the problem?
