3 phase lamps (Uplighters)

Discussion in 'General Discussion' started by bijoykr, Sep 6, 2007.

  1. bijoykr

    bijoykr

    Joined:
    Aug 27, 2007
    Messages:
    38
    Likes Received:
    0
    Location:
    INDIAN living in QATAR
    Dear Friends,
    Can we control 3 phase lamps through our Relays? can we use the 3 channels as 3 phase and giving same group adress? is there any problem in using so, will it affect the hardware?

    Thanks & regards

    Bijoy K R
     
    bijoykr, Sep 6, 2007
    #1
  2. bijoykr

    paulw11

    Joined:
    Dec 4, 2006
    Messages:
    97
    Likes Received:
    0
    Location:
    Blue Mountains, NSW, Australia
    Use a contactor

    Hi,

    I would use a 3 phase contactor switched from a single C-Bus relay channel. This will save relay channels, remove the dependency on relay programming and also eliminate the risk of a relay failure leaving one phase off when the others are on.

    Paul
     
    paulw11, Sep 6, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Loss of one phase?

  2. UPS and Phase Switching

  3. General Information about Fluorescent Lamps and Compact Fluorescent Lamps

  4. Controlling 3 phase devices via CBUS

  5. 3 Phase Clamp on, serial output?

  6. 3 Phase power usage meter

  7. Piced and Moon Phase

  8. Current measurement units on 3 phase

Loading...