5500CN2 Client Connected

Discussion in 'C-Bus Wired Hardware' started by constantcharge, Nov 2, 2016.

  1. constantcharge

    constantcharge

    Joined:
    Nov 23, 2004
    Messages:
    83
    Likes Received:
    0
    Location:
    Adelaide
    Hi Guys,

    Had this a few times where connected to 5500CN2 and for some reason the connecting is dropped, this causes the device to CN2 to think a client is still connected (can bee seen in the web ui "client connected") then the only way to recover is to reset the device either power cycle or via control ip utility.

    This works fine locally but has happened on remote sites. Is there a option to send reset via another method ? The old 5500CN lantronix it was possible to do via telnet but I think this was removed in the CN2.
     
    constantcharge, Nov 2, 2016
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. CTC Client problem

  2. Two Wired networks connected by 2 Wireless gateways

  3. Toolkit not able to discover all connected devices

  4. Switchs connected via patch panal.

  5. Backing Up Project When Connected Remotely

  6. Fully Connected Networks

  7. Wireless Client Table empty

  8. CNI (5500CN) vs CNI2 (5500CN2)

Loading...