560110R Amplifier specs

Discussion in 'Multi-Room Audio (MRA) and MARPA' started by p0rt3r, Apr 2, 2012.

  1. p0rt3r

    p0rt3r

    Joined:
    Dec 16, 2010
    Messages:
    51
    Likes Received:
    0
    Location:
    Moscow
    Hello!

    What is the right supported output impedance of the low-power amp? Installation manual has the sketch of the rear amp's panel where "6-8 Ohm" line is present. At the end of the document the table with specifications contains "Maximum power output - 10W RMS into 4 Ohm". So does the 4 ohm load supported or not?
     
    p0rt3r, Apr 2, 2012
    #1
  2. p0rt3r

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,397
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    You should be OK into 4 ohms.

    6-8 ohms is preferred.
     
    ashleigh, Apr 2, 2012
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Amplifier IR control

  2. Tinny sound from amplifier

  3. 360 Deg. PIR specs

  4. MRA Amplifier & Local Input Only

  5. Limit Volume of C-Bus Amplifier

  6. Multiple stanalone amplifier in 1 network

  7. 560110R Firmware

  8. New eDLT has dust specs behind fascia

Loading...