5753PEIRL and network traffic overload

Discussion in 'C-Bus Wired Hardware' started by 2SC, Apr 11, 2011.

  1. 2SC

    2SC

    Joined:
    Oct 10, 2006
    Messages:
    345
    Likes Received:
    0
    Location:
    Athens, Greece
    I am quoting for a project where I want to use many 5753PEIRL trying to keep constant the light level independently from the ambient light (light fittings will dimmed down when the sun shines).

    I was wondering if a network with 28 pcs of 5753PEIRL and 9 pcs of 5502DAL will run smoothly since this technique will put a lot of load to the network. The rest units in this network are 2 gang switches which will rarely being used.
     
    2SC, Apr 11, 2011
    #1
  2. 2SC

    Newman

    Joined:
    Aug 3, 2004
    Messages:
    2,203
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    I assume that there is only 1 sensor per Group Address? If so, then I don't see a big problem.
     
    Newman, Apr 11, 2011
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 5753PEIRL and Pets

  2. High error rate using traffic analyser

  3. GIU 5504GI network traffic when direct messaging

  4. Serial interface traffic optimisation

  5. PIR 5753L and 5753PEIRL

  6. Multisensor ,C-Bus Traffic and C-Touch

  7. 5753PEIRL "0" lux setting and overide

  8. Senll to control 5753PEIRL and lamp

Loading...