Accidently loaded b&w to colour screen

I have encounted a problem with a colour screen where I have loaded a b&w project into the screen by mistake, and now even the default and the correct project will only show in the top left hand 1/4 of the screen. Any help would be much apeciated.

regards,
grant

 

Could you describe exactly how you managed to do this ?

Can you not just transfer the correct project to the unit ?

 

In the project folder I had a b&w screen project aswell as the colour project.
When I did my archive I achived all the files in the project folder and found that that screen loads the first project in the list of files. This happened to be the project for my b&w screen in the same installation. The b&w project has been derived from the colour project so was save in the same folder. I then reloaded the correct project after removing b&w project to a separate folder and experinced the problem. I then loaded the default project to try to correct the problem and found that the screen behaved the same. I have attached same screen grabs.

Regards,
Grant