Auto Level Store in Recovery 1.12.5

Dear Friends,

I am facing an issue in Recovery Tab while checking Auto Level Store in Toolkit 1.12.5
What happens is, when I chose different group addresses in all slots then the Auto Level Store Checks remain intact when I restart Toolkit again, otherwise if any channels have same group addresses then after checking Auto Level Store and Restarting Toolkit, the checks on those channels with same group addresses vanishes.

Same happens if Auto Level Store checks are removed and Level of the Channels is set at ON(100%) while same group addresses are mapped on any channels then after restarting Toolkit the status of those channels becomes OFF.

P.S. The project is a big one and I cannot spare this much group addresses as I am focusing on using Area Addresses. Secondly Images attached are offline but same happens when the system in online and the System is not Restoring Automatically to ON State.

Anyone Please help, guide or comment.

Regards,

Hamza Shamim Siddiqui.

 

Hi Hamza Shamim Siddiqui

I also have the same group address used across multiple channels.
Though I do not have group addresses across multiple units or use area addresses.
Just tried it on Toolkit 1.13.0 with my 8 channel dimmer.
It did not have any trouble storing the auto level restore settings after restarting Toolkit.

Back up your projects and install the latest Toolkit and see how it goes.

 

Latest version of Toolkit and old versions available here.

http://www2.clipsal.com/cis/technical/downloads/c-bus_toolkit

 

I have a similar bug with 1.13.0 using the bus couplers. If I have it setup as a bistable switch on/off... next time I open it, it says custom. Close the device dialogue box and then re-open, its back to normal.