c-gate misses units

Discussion in 'C-Bus Toolkit and C-Gate Software' started by Tonyo, Aug 11, 2004.

  1. Tonyo

    Tonyo

    Joined:
    Aug 4, 2004
    Messages:
    48
    Likes Received:
    0
    Location:
    Canberra
    I tried running c-gate 1.5 with and without the updates on my windows xp system. It connects fine but only reports between 5 and 11 of the 34 units when I do a tree command. It sometimes says I have zero units but shows some, other times it says 34 but only shows 11. Can anyone offer any advice?
    Tony :confused:
     
    Tonyo, Aug 11, 2004
    #1
  2. Tonyo

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    The most likely cause is poor network communications. Use the C-Bus Diagnostic Software http://www.clipsal.com/cis/downloads.php3#Diag to see if you have reliable communications.

    If not, then check
    - burdens
    - number of units
    - power supplies
    - network voltage
    - cable length
    - clocks
     
    Darren, Aug 11, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. C-Gate and 5034NIR Units

  2. Article Discussion Wireless - Adding More Units

  3. Sort on "Units on Network"

  4. Article Discussion Logic functions in output units

  5. Wireless Units Fail To Scan

  6. Use of the Learn options in Wireless units

  7. Add C-Bus Enabled units to toolkit1.1.4

  8. C-Gate Documentation 1.0 for C-Gate 2.5 released

Loading...