C-Touch

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by harro, Oct 8, 2007.

  1. harro

    harro

    Joined:
    Mar 18, 2007
    Messages:
    32
    Likes Received:
    0
    Location:
    Gold Coast
    I have a small problem with Scene Groups. On a C-Touch page I am trying to construct a similation of 4 button (On/Off) switch with a master button controlling the other 4 buttons as a scene, i.e. all on or all off. I have used single groups to control each of the 4 buttons (call them groups 1,2,3, and 4) and a scene group to control all 4 together. I have used active/inactive colours to indicate on/off. In scene components in scene editor the group that is no 1 in the list of components i.e. in my case group 1 but can be any group, whenever that group is activated it will also trigger the active colour for the master button, but not activate the scene. In all other respects the similation works OK. I have noticed that if I place a dummy group as 1st group in the component list I don't get the problem. Any ideas......

    Harro
     
    harro, Oct 8, 2007
    #1
  2. harro

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    If you are using a key function other than "Scene" to control the groups in a Scene, then the indicator will show the state of the first group in the scene. There isn't much else it can do.

    If you use the "Scene" key function, the indicator will show the actual state of the Scene.
     
    Darren, Oct 15, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.