Catalogue numbers in Toolkit

Discussion in 'C-Bus Toolkit and C-Gate Software' started by Dave Byron, May 22, 2006.

  1. Dave Byron

    Dave Byron

    Joined:
    Aug 3, 2004
    Messages:
    835
    Likes Received:
    0
    Location:
    Casurina
    Updating the catalogue numbers in Toolkit.
    If a new unit without a power supply is added to toolkit the “P” is on the catalogue number, but if the unit was pre-existing and did not have a number when Toolkit saves to the database it adds the catalogue number minus the “P”.

    The end result is Toolkit says all units have power supplies which is not correct.
    dave
     
    Last edited by a moderator: May 22, 2006
    Dave Byron, May 22, 2006
    #1
  2. Dave Byron

    Duncan

    Joined:
    Jul 23, 2004
    Messages:
    925
    Likes Received:
    0
    Location:
    Salinas de Garci Mendoza, Bolivia
    Thanks Dave, have logged this.
     
    Duncan, May 22, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Can not add the CNI 5500CN by catalogue number.

  2. Catalogue Number Field too Small

  3. maybe trivial, but, displaying of Part Numbers

  4. matching serial numbers from network to database

  5. Catalogue Number Disapears When Transfering Unit to DB

  6. Key Numbers on the Graphic for the KEYSCEN4

  7. C-Bus Application numbers

  8. Time for a new product catalogue?

Loading...