Circular Scene Triggering - Error

Hey,
Does anyone know if there is away around the error that says:
"There are circular Scene Triggers. There scenes will trigger each other. Please chang a Scene Trigger or the scene item which is doing the triggering."
when you are trying to get scenes configured?

This is a really big problem with what i am trying to get my touch screen to do.

I am get the following done:
- when the user triggers the scene one load will turn off (instantaniously)
- one second wait
- turn off the second load
- wait one second
- Continuously for 7 separate loads.

Proposed way to be carried out:
- One scene is triggered which turns off Load 1 and triggers a phantom scene (that works off a pulse off new PICED software for the one second delay)
- The next scene is triddered by the first one through that group address which will turn off the second load and start another phantom group address for one second delay
- and so on for all the other loads

I have created all the scenes and had it parcially working but i changed the timing and a few other things and i am getting this error. I know for sure that the cbus will not keep looping forever but the software is stopping me from finishing this.

Please help,
George

 

Thanks, i found the problem after a few hours of deleting the scenes and starting again. But it all works now! and it looks awsome

I know what doing this with scenes is not good practice but i dont know any other way that I can get the loads to turn off like i want them to. If anyone has any ideas on how to do this then please tell me because this is a very long process especially if you want to make small changes (e.g. change the delay period from 1 second to 2 seconds)

 

The only other way of doing this is to use logic.