CNI config for Touchsoft App

Discussion in 'C-Bus Wired Hardware' started by Dean Cee, Aug 20, 2010.

  1. Dean Cee

    Dean Cee

    Joined:
    Aug 16, 2010
    Messages:
    5
    Likes Received:
    0
    Location:
    Queens Park
    I have recently added a CNI to my C-Bus network to enable me to use the Touchsoft app and control my C-Bus network from my Iphone. For some reason I can't get the Touchsoft app to communicate with the CNI??. I was wandering if anyone that has this working could post the config of their CNI?

    I am able to Telnet/HTTP or use Toolkit/IP Utility to access the CNI from the LAN but I think maybe one of the CNI settings are not right?

    Any thoughts or suggestions would be greatly appreciated.:confused:
     
    Dean Cee, Aug 20, 2010
    #1
  2. Dean Cee

    Dean Cee

    Joined:
    Aug 16, 2010
    Messages:
    5
    Likes Received:
    0
    Location:
    Queens Park
    Faulty cni!

    After some discussion with Clipsal Tech support, I swapped out my CNI as it was faulty!!
    Thankfully my config was correct.
     
    Dean Cee, Aug 27, 2010
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. iPhone app. New CNI.

  2. IPOD App from Touchsoft

  3. Wiser Iphone app to control CNI

  4. Cbus CNI App V1.3

  5. Wiser Power Measurement 'Virtual Channel' config for Dual Solar

  6. CBUS Training and Config for personal install

  7. iPad App now on App Store

  8. CNI 5500 module vs Wiser CNI

Loading...