CNI to Crestron

Discussion in 'General Discussion' started by nickrusanov, Jan 25, 2008.

  1. nickrusanov

    nickrusanov

    Joined:
    Aug 5, 2004
    Messages:
    308
    Likes Received:
    0
    Location:
    russia
    Is it possible to interface C-Bus to Crestron through TCP/IP - CNI unit? Or should we use PC interface only?
     
    nickrusanov, Jan 25, 2008
    #1
  2. nickrusanov

    Conformist

    Joined:
    Aug 4, 2004
    Messages:
    787
    Likes Received:
    74
    Location:
    Adelaide, South Australia
    Yes it is fine to use the CNI. Use a TCP/IP client module, point it to the IP address of the CNI and use port 10001. TX and RX joins should be connected the same as RS232. It's also wise to monitor the connection status join just in case you need to re-establish comms (if the connection is dropped for some reason).

    Cheers
     
    Conformist, Jan 25, 2008
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Help with CBus2 Interfase with Crestron

  2. Crestron Interfacing Problem

  3. Crestron Interfacing Problem

  4. Crestron integration and PCI v4

  5. Crestron through CNI

  6. Crestron CNI interface

  7. CNI 5500 module vs Wiser CNI

  8. CNI to CNI Communications

Loading...