Comms failing on PICED to Network

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by mbloodyl, Apr 19, 2009.

  1. mbloodyl

    mbloodyl

    Joined:
    Apr 19, 2009
    Messages:
    4
    Likes Received:
    0
    Hi, Currently and always have had problems with PICED failing to communicate to the network after a relatively short time of being connected.
    Does anyone have an idea of the issue I am having and is there a fix?
    PC to network via serial on PAC. Running simple logic etc on one network.
     
    Last edited by a moderator: Apr 20, 2009
    mbloodyl, Apr 19, 2009
    #1
  2. mbloodyl

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,397
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    How short is short?

    PICED, in simulation mode, will run for about a day and then disconnect.

    If you want something that runs continuously you need HomeGate or SchedulePlus.

    PICED is for commissioning and simulation of the devices you are commissioning.
     
    ashleigh, Apr 20, 2009
    #2
  3. mbloodyl

    mbloodyl

    Joined:
    Apr 19, 2009
    Messages:
    4
    Likes Received:
    0
    Short being approx 15 - 20mins.
    I notice that the PAC status light stops flashing when comms are lost.
    Roared back into life once USB was disconnected.
     
    mbloodyl, Apr 20, 2009
    #3
  4. mbloodyl

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,397
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    So do you mean PICED stops, or the PAC stops ?
     
    ashleigh, Apr 20, 2009
    #4
  5. mbloodyl

    mbloodyl

    Joined:
    Apr 19, 2009
    Messages:
    4
    Likes Received:
    0
    Not too sure. PICED works in simulation but stops sending the infomation to the network because 0/1 networks on-line shows at the bottom of the screen. Once connected for the first time all ok but after the 15mins this happens.
    Also PAC stops but PICED can at times still show 1/1 networks online but nothing happening. PICED will simulate lighting being switched on and off but physical switching doesn't take place.
     
    mbloodyl, Apr 21, 2009
    #5
  6. mbloodyl

    mbloodyl

    Joined:
    Apr 19, 2009
    Messages:
    4
    Likes Received:
    0
    Problem solved! Firmware conflict on PAC with Toolkit running alongside PICED.
     
    mbloodyl, Apr 24, 2009
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Network Comms

  2. network failing to open

  3. Touch Screen Failing to Restart

  4. PIR's failing to trigger load

  5. DLT's failing

  6. Failing touch screens

  7. Network comms error?

Loading...