DALI Ballast

Discussion in 'General Discussion' started by suresh, May 26, 2010.

  1. suresh

    suresh

    Joined:
    May 19, 2008
    Messages:
    9
    Likes Received:
    0
    Hi,

    I have a requirement in an Commercial Project, I have connected 64 DALI (0-63) Ballast to CBus Dali Gateway. I need to assign individual CBus Group to Each Dali Ballast and control Individual lights thru the CBus Wall Panel. Can anybody tell that is it possible to assign CBus Group address from 0-63 to the Dali Ballast from 0-63 which is connected on the Dali Gateway and control individually. This Application is used in a Workstation area where each user have a Wall panel which we can control the Light which is used by him.

    Please suggest.

    Thanks & regards
    Suresh
     
    suresh, May 26, 2010
    #1
  2. suresh

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,397
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    Yes. Very easy.

    The Cbus DALI gateway allows a mapping from the cbus group to a DALI short address (ie Ballast number).
     
    ashleigh, May 27, 2010
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. DALI Gateway

  2. Touch Screen to display Load blown or not for a DALI Ballast through a C-BusDali Gwy

  3. DALI Ballast Power Consumption in OFF state

  4. C-Bus and LED Dimming using Tridonic Ballast

  5. DALI ballast control over CBUS

  6. How to get DALI Ballast Status Report in Schedule Plus Software

  7. any DSI ballast exept TridonicAtco?

  8. Is that possible to make a Cbus ballast or LED driver?

Loading...