DLT Problem?

Discussion in 'General Discussion' started by jonmaine, Oct 26, 2008.

  1. jonmaine

    jonmaine

    Joined:
    May 31, 2008
    Messages:
    15
    Likes Received:
    0
    I am having an issue with one of my dlt units where it will either not go onto the second screen or it just does so for say half a second or so whilst pressing the fifth button. Is this a faulty unit or is there a setting somewhere I have not found which will control this?

    All ideas gratefully received.

    :confused:
     
    jonmaine, Oct 26, 2008
    #1
  2. jonmaine

    Mark

    Joined:
    Oct 28, 2004
    Messages:
    196
    Likes Received:
    1
    Location:
    Grenoble, France
    DLT Page One

    Hi,

    There are two things that can make a DLT stick to the first page only:

    1. If you have no functions configured on buttons 5-8 the DLT will not go to the second page as the buttons there won't do anything.

    2. Join Mode: If join mode is enabled it can force the DLT to either page one or page two depending on the state of the Join group. Check in the Toolkit UI that Join Mode is disabled.

    In any case, the unit changing to the second page then immediately changing back sounds odd. If neither of the suggestions above are the cause of the problem then i'd suggest contacting Tech Support.

    Cheers,
    Mark.
     
    Mark, Oct 27, 2008
    #2
  3. jonmaine

    SeamlessAutomation

    Joined:
    Oct 5, 2008
    Messages:
    32
    Likes Received:
    0
    DLT Problem

    Hi Jonmaine

    I Have had a similar problem not sure if this will solve yours but under the "Indicators" Tab in toolkit there is a "fallback to first page" setting so basically after going to the second page the switch can fall back to the first page after a preset time just check that the preset time at the moment is not set to say 1 second, that fixed my issue

    Cheers
     
    SeamlessAutomation, Oct 27, 2008
    #3
  4. jonmaine

    jonmaine

    Joined:
    May 31, 2008
    Messages:
    15
    Likes Received:
    0
    It was the fallback to first page set at only 1 second, cant remember changing it though!!:)
     
    jonmaine, Nov 2, 2008
    #4
  5. jonmaine

    SeamlessAutomation

    Joined:
    Oct 5, 2008
    Messages:
    32
    Likes Received:
    0
    DLT Problem Solved!!

    You probably never changed it :) i think there was a small amount of DLTs that came out with the Fall back setting defaulted to 1 second.
     
    SeamlessAutomation, Nov 4, 2008
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.