Does a PAC need rebooting ?

Hi All,

Having previously connected to my PAC I now find this fails. Is there a way to reboot to PAC ?

Chris

 

I also want more information on the PAC as well. Did it just fail suddenly and what failed? Logic/Schedule/scene/programs...??

Last time (the only time so far) I used PAC, logic stopped running after I used the PAC as interface to download settings with Toolkits. Since I treated it the same as a mono C-Touch, I simply re-loaded the program from PICED and it worked again (sounds like re-booting). Afterwards I was told that if I unplugged the USB cable that would have worked again without re-loading the program. I didn't have chance to verify that in that project but I'll have chance later.

 

I haven't really had an opportunity to try too much. I have tried 2 different computers though with no effect. I suppose if I remove the cbus connection from the PAC that will reset it ?

Chris

 

Removing the C-Bus connection will make the PAC re-boot.

If you are using it as a PC Interface, this will stop the logic from running. Unplugging the USB cable in this case will also make it re-boot.