Ga

Just setting up a program with multiple networks
I have set the touch screen up on network 1 with the bridges to each network below this, so that the commands from the screen go directly to each network
I have created a new application for each network so that there can be no "stray" commands going across networks
On setting up 1 application I have noticed that instead of "unused" I have "Group 255" instead & I cannot edit it.
Is this an issue & if so what would the solution be (hoping it's not delete & re-do !!)
Thanks

 

Hey,

That isn't a problem, <unused> is actually Group 255. Some places in toolkit it just doesn't change the name properly. Also just as maybe an obvious thing, but you cannot use Group Address 255 anyway. The 255 group addresses are from 0-254.

J

 

Thank you. I had suspected as much but as I had never come across this before,decided it was better to ask
Thank you again for the advice