Glitch on up button

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by Corin, Jan 23, 2009.

  1. Corin

    Corin

    Joined:
    Jun 19, 2007
    Messages:
    8
    Likes Received:
    0
    I recently was working on a mark2 with logic using piced 4.41. I added a button and had the key function set to 'UP' and controlled item to 'Scene Groups'. The ramp rate is defaulted to 4sec. If Ichange this to any other setting and continue it works fine. As soon as i enter the buttons set up page again it defaults back to 4 seconds and saves.:confused:

    It is also happening on the 'DOWN' setting.

    Both buttons worked fine if given just a single group address.

    Please let me know of a solution:)
     
    Corin, Jan 23, 2009
    #1
  2. Corin

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    It only gets reset to 4 seconds when you re-open the component editor. Just set it to 8 seconds and close the editor and you will have an 8 second ramp rate.

    New issue #16008.
     
    Darren, Jan 28, 2009
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Master Off Button - XKill

  2. Telephone Interface glitch?

  3. Dont just miss the OK Button....

  4. Inhibiting a button via another Switch or homegate

  5. Saturn Button Labels

  6. Programming button on 1ch & 2ch Relays

  7. DLT Button reseting

  8. PICED 4.4.1 glitch

Loading...