Help with basics of Cbus setup

dlt you cannot read the labels from the network
eDLT you can
Have a look at this link its an older manual but should help.
http://automatedhome.dp.ua/wp-content/files/C-Bus_Basics_Training_Manual_Vol_2.pdf
If I had checked the forum whilst on holiday in the UK I may have been able to help locally
only came back to Aus on Friday.
Colin

 

Thanks Colin, will take a look

 

Got it working now, so labels are a changing.

Next is how to amend the scenes allocated to keys. Anyone help?

 

OK, bean playing around with toolkit, but have noticed an issue. I have 6 DLT Saturn units, three of which have the backlight on, but the other 3 don't. I have checked that the brightness is maxed on the three dull units, but is there anywhere else i need to check. Strange that three would be dull and in the three rooms that are reception type areas.

Any ideas?

Thanks

 

See this YouTube video
Should help with scenes
With regard to screen brighness couple of suggestions
1 reset the unit on the gui save the blank config then reprogram
Or
2 if you under the concept of unit addresses
Change the the addresses of 2 units (one ok and one not ok) on the network and then save the database copies to the network and see what the results are.
Becareful with this suggestion as it does require understanding of C-Bus
Colin

 

Thanks Colin suggestion two is way over my head. Will try a reset of the unit.

I opened up one of my units to see if I could swap them around, but once I took the face plate of I could not see any screws to remove the switch from the wall. Does the inner part pop out. Did not want to poke about with a screw driver too much and I can't find an install guide for the UK square version.

Thanks

 

No Joy on option 1, the reset

 

With regard to the fixing it should be held back with 2 screws on the left and right of the switch. I can see the screws have not been used therefore the installer has come up with their own way of securing it.
For the screen brightness tty this to see if the screen actually illuminates
Go to the indicators tab and change the radio button to Level of a Group, select a known group in the drop down box and save. Try switching that group ON to see if the screen illuminates.

 

Hi Wonkey

Nothing happened. Looks like I have three faulty screens to live with.

Thanks