Home Gate intermittent connection

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by dsamson, Oct 20, 2006.

Page 3 of 3
  1. dsamson

    dsamson

    Joined:
    Aug 23, 2004
    Messages:
    49
    Likes Received:
    1
    Location:
    Sydney
    Comming back to this message.
    Just a thought. Can the C-Gate that runs for HomeGate be setup not to force a rescan/sync if the error is related to an input unit? HomeGate should work fine as long as all the output units are OK.
    Sometimes is difficult to find the input units with an intermittent fault and on most of the projects control via HomeGate is more important than a single faulty switch.

    Regards
    Daniel
     
    dsamson, Mar 3, 2007
    #41
  2. dsamson

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,398
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    The way that C-Gate works for handling device and network errors is on the table for a re-working.

    This is some time away, though.
     
    ashleigh, Mar 4, 2007
    #42
Page 3 of 3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Home Gate 2.6.0 released

  2. Home Gate vs Multimedia Dynamics vs Home Touch Systems

  3. Intermittent PIR Issue

  4. What is a difference between AMX Home Automation and C-bus Home Automation

  5. intermittent network scan failure

  6. Intermittent dimmer channels

  7. CNI connection issues - "connection already in use"

  8. Intermittent Communication

Loading...