I'm just been lazy.

Just installed a light with 25 x 20w halogens (looks like the sun), it has a large 12v toroidal transformer. My question is in order to dim the 500w load which Clipsal dimmer should I use.

Regards
Steve

 

This forum is generally based around C-Bus. Are you looking for a C-Bus dimmer or a stand-alone one?

 

Thanks Newman,

C-Bus. As the current load is just over 2A (2.08) was going to use a 4 channel 2A (L5504D2A) but not sure as the load is very close to the limits, and these are only calculated values.

Regards
Steve

 

you should use l5104d5.

 

I'd go with an L5504D2U, the 4 x 2.5A DIN Universal Dimmer for that job. Hope you can put the other dimmer channels to good use .

http://www2.clipsal.com/cis/__data/page/428/L5504D2U Series data sheet2.pdf

 

Thanks Newman, sounds like the most cost effective solution.

Steve