Interfacing CBus Lighting Control with Alarm Systems

Discussion in 'General Discussion' started by Halv0r, Apr 12, 2007.

  1. Halv0r

    Halv0r

    Joined:
    Apr 12, 2007
    Messages:
    1
    Likes Received:
    0
    I am just starting out learning how to use CBus and i have been tasked with removing a Clipsal HomeMinder system from a network and using just interfacing from an alarm system to control the lights from CBus.

    I would appreciate it greatly if anyone had any ideas how to go about this.

    From what i can guess you would wire some voltage free contacts from the alarm panel to change state when you wish for the lights to switch on. The lights would be linked to an area in CBus then to a contact.

    Any thoughts or tips would be greatly appreciated.
     
    Halv0r, Apr 12, 2007
    #1
  2. Halv0r

    tobex

    Joined:
    Nov 3, 2006
    Messages:
    728
    Likes Received:
    0
    Location:
    Sydney, Australia
    tobex, Apr 12, 2007
    #2
  3. Halv0r

    fleetz

    Joined:
    Nov 21, 2005
    Messages:
    362
    Likes Received:
    9
    If you have not got the alarm panel have a look at the Ness M1 with a C-Bus interface. There is a V2 version C-Bus interface due very soon to resolve a few issues so wait for that one. http://www.ness.com.au/m1/index.htm

    Cheers,

    Fleetz
     
    fleetz, Apr 12, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Interfacing to Control 4

  2. alarm systems

  3. Cbus intergration with Bosch Solution 64 Alarm System

  4. best way to control an alarm via a spectrum touch scree(with logic)

  5. Choice of AC Systems with Full CBUS Capability

  6. Other systems to control C-bus other than Wiser

  7. Cbus integration with hills reliance 24 alarm

  8. Can RTI control CBus lighting using WISER

Loading...