IR Target Unit

Discussion in 'Infrared (NIRT, IR Reader) and CIRCA' started by ranilroshan, Oct 18, 2007.

  1. ranilroshan

    ranilroshan

    Joined:
    Feb 11, 2006
    Messages:
    79
    Likes Received:
    0
    Location:
    Sri Lanka
    Anybody know what is the suitable cable for the IR target unit (eg. 8050FT-ceiling mounted IR target) if the given 1.8m cable is not enough for wiring. Also specify the maximum length of such cables.
     
    ranilroshan, Oct 18, 2007
    #1
  2. ranilroshan

    NickD Moderator

    Joined:
    Nov 1, 2004
    Messages:
    1,427
    Likes Received:
    64
    Location:
    Adelaide
    Did you read the installation instructions?

    "Extension leads may be used on the emitter leads of up to 50m of category 5 or similar cable, such that the cable capacitance does not exceed 10nF."

    Nick
     
    NickD, Oct 19, 2007
    #2
  3. ranilroshan

    ranilroshan

    Joined:
    Feb 11, 2006
    Messages:
    79
    Likes Received:
    0
    Location:
    Sri Lanka
    For the case of MRA system can I use CAT5 cable to connect IR Tube Target and MRA Amp directly. If so how many cable pairs I need and what are those pairs
     
    ranilroshan, Oct 19, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Install New Unit Function

  2. Unit conflict detected

  3. Heat From Dimmer Unit.

  4. IR Distribution system - IR target positions.

  5. 8050TT IR Tube Target

  6. Multi Level sensor target range problem

  7. 5753PEIRL Light Level Target setting

  8. SENLL Target Lux Too Small

Loading...