Jetmaster fire place and cbus

Discussion in 'C-Bus Wired Hardware' started by chrip, May 16, 2013.

  1. chrip

    chrip

    Joined:
    Apr 30, 2013
    Messages:
    4
    Likes Received:
    0
    Location:
    Melbourne
    Hello,

    I am planning to buy a jetmaster 1050 low low fire place and was wondering how to integrate this into my cbus system?

    Has anyone had success in switching this fire place on/off via cbus? I understand it's a self contained unit and generates it's own electrical power (i.e. millivolt signal) to start up.
     
    chrip, May 16, 2013
    #1
  2. chrip

    paulw11

    Joined:
    Dec 4, 2006
    Messages:
    97
    Likes Received:
    0
    Location:
    Blue Mountains, NSW, Australia
    Hi

    The Jetmaster web site is short on detail, but I imagine all you need is a contact closure, so you could use any of the DIN relays or even the L5108 low voltage relay. You will need to contact Jetmaster to find out what the maximum cable length is between the fire and the relay - You may need to mount a relay close to the fire if your C-Bus relays are some distance away. If you didn't want to put a C-Bus relay near the fire you could use C-Bus to switch a 240v contactor connected to the fire.
     
    paulw11, May 17, 2013
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. AMX and cbus use together,can cbus feeback to AMX?

  2. Best place to find Cbus equipment?

  3. Is there a place to tender for the services of a senior coding expert ?

  4. How does communication take place through a cat 5 cable in CBUS

  5. Using Acer Tablet + cbus network interface in place of touch Screen ?

  6. Cbus and Brivis heating and a/c

  7. Control of a UK gas fire

  8. Wiser App and Amazon Fire TV

Loading...