L5504 amp channel capacity

Discussion in 'C-Bus Wired Hardware' started by remedy, Oct 29, 2009.

  1. remedy

    remedy

    Joined:
    Nov 22, 2008
    Messages:
    16
    Likes Received:
    0
    Hi

    I have a large installation with 15 rows of twin 0-10 volt ballasts. I have already worked out that it will take 4 channels to drive one row of ballasts. Can you common up the channels so that i could run 1 control wire per row and connect it into the 0-10 volt unit.

    Thanks for any help
     
    remedy, Oct 29, 2009
    #1
  2. remedy

    Newman

    Joined:
    Aug 3, 2004
    Messages:
    2,203
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    Page 4 of the Installation Instructions shows you how to wire the unit up when you want to share a single common connection between channels, which is useful for reducing the amount of cable needed.

    Connecting the channel outputs in parallel to increase the channel drive capability will most likely damage the Analogue Ouptut unit.
     
    Last edited by a moderator: Oct 30, 2009
    Newman, Oct 30, 2009
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Desktop Amp.

  2. Speaker connections to amp

  3. Memory capacity of BW touch screen

  4. Slave AMP locks on Local

  5. LED lamps and 4 channel / 8 channel dimmers

  6. 10 Amp 12 Channel Voltage Free Relay.

  7. Using a two channel relay for single channel ?

  8. Best solution for measuring water capacity

Loading...