Light Sensors

Discussion in 'C-Bus Toolkit and C-Gate Software' started by Gary Ginn, Jun 14, 2005.

  1. Gary Ginn

    Gary Ginn

    Joined:
    Jun 9, 2005
    Messages:
    1
    Likes Received:
    0
    I am currently using the C-Bus public release protocol to control a C-Bus network using an Allan Bradley PLC.
    Is it possible to read the actual light sensor reading using the public release protocol.
    If so how?
    Gary Ginn
     
    Gary Ginn, Jun 14, 2005
    #1
  2. Gary Ginn

    Newman

    Joined:
    Aug 3, 2004
    Messages:
    2,203
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    Gary

    The Pulbic Release Protocol information only allows you to turn Group Addresses On, Off and Ramp them up & down.

    To get access to the information you're after you will need to contact the C-Bus Enabled program which means signing an agreement etc.

    More info here: http://www.cbus-enabled.com/default.html
     
    Newman, Jun 14, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Humidity & Barometric Pressure Sensors

  2. Occupancy sensors

  3. Occupancy sensors and A/C vents

  4. C-Bus temperature sensors 5031TS

  5. Indoor/Outdoor/360 Deg Sensors

  6. External Light Level Sensors

  7. Using motion detection and light sensors in office areas

  8. CBus light switch no longer turns off light

Loading...