Mounting 5100DT temp sensor

Discussion in 'C-Bus Wired Hardware' started by Hollywoodperth, Sep 18, 2018.

  1. Hollywoodperth

    Hollywoodperth

    Joined:
    Sep 9, 2018
    Messages:
    38
    Likes Received:
    0
    What is everyone doing to mount the 5100DT temp sensor?

    I've seen the 5031RDTSL which comes with the c-bus interface but it's only in a 2000 series? I'm using Saturn wallplates.

    I've also seen the Airtopia sensor that they use with a wallmate style plug. I'm not against this (it looks neat) but in WA our internal walls are brick, not gyprock so not sure how to make this work that you could get to it to replace it in the future.

    All advice welcome
     
    Hollywoodperth, Sep 18, 2018
    #1
  2. Hollywoodperth

    NickD Moderator

    Joined:
    Nov 1, 2004
    Messages:
    1,427
    Likes Received:
    64
    Location:
    Adelaide
    If you mount it in the brick you may introduce a large lag in the temperature reading due to the large thermal mass of the brick.

    I would look for somewhere that is about 1.5m off the ground, in something that is either insulated from other heat sources or has a small thermal mass of its own... a wooden architrave, or the bottom of a built in overhead cupboard, or something like that.

    Nick
     
    NickD, Sep 20, 2018
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Cbus temp sensor

  2. Temp Sensor enable

  3. Temp Sensor with CTC

  4. outdoor temp sensor

  5. Using temp sensor instead of thermostat

  6. Using temp sensor outside

  7. Temp sensor problem

Loading...