Multiple Cbus Connections

Discussion in 'C-Bus Wired Hardware' started by DarylMc, Dec 28, 2011.

  1. DarylMc

    DarylMc

    Joined:
    Mar 24, 2006
    Messages:
    1,315
    Likes Received:
    49
    Location:
    Cleveland, QLD, Australia
    I would like to set up 3 or possibly 4 TCP connections to CBus on my network to allow Homegate, Diagnostic Utility, Touchsoft and possibly another application to all be connected at the same time.
    Perhaps some sort of embedded interfaces with RS232 that I could connect to an ethernet device server.
    Suggestions for various ways to do this or alternatives to multiple CNI units?
    Thanks
     
    DarylMc, Dec 28, 2011
    #1
  2. DarylMc

    tobex

    Joined:
    Nov 3, 2006
    Messages:
    728
    Likes Received:
    0
    Location:
    Sydney, Australia
    Im not the best person to ask but is there scope for putting WISER into this design ?
     
    tobex, Dec 28, 2011
    #2
  3. DarylMc

    DarylMc

    Joined:
    Mar 24, 2006
    Messages:
    1,315
    Likes Received:
    49
    Location:
    Cleveland, QLD, Australia
    DarylMc, Dec 28, 2011
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Two serial connections to a PCI interface ?

  2. Mutliple connections to CNI fail

  3. PICED Socket connections

  4. Speaker connections to amp

  5. TCP connections (OpenClientSocket)

  6. TCP Socket Connections in Piced Logic

  7. wiser and internet connections merge with out lan wire?

  8. NEO, multiple timers on multiple keys, same group

Loading...