Multiple stanalone amplifier in 1 network

Discussion in 'Multi-Room Audio (MRA) and MARPA' started by BigBoyVn, Sep 3, 2010.

  1. BigBoyVn

    BigBoyVn

    Joined:
    Aug 3, 2008
    Messages:
    42
    Likes Received:
    0
    Dear All,

    Can I use 2 Audio Distribution Units for amplifier standalone installtion (no matrix switch) in 1 C-Bus network?

    In installation instruction doccuments, it says:
    + If more than 1 Amplifiers connected in serial, it should be set 1 to be master.
    + Maximum 8 amplifiers can connect in serial and cable length limit to 45m.

    In my installation, I use 3 Audio Distribution Units, each Audio Distribution Units follow by 3 amplifiers in serial.

    My problems is:
    + I can only set 1 amplifier to be Master - instead of 3 Master - Each master for 1 music line from Audio Distribution Units.
    + If I adjust volume for the Master, volume of all other amplifier also change.

    Would you please advise how to solve this problem.

    Thanks and Best regards,
    BigBoyVn
     
    Last edited by a moderator: Sep 6, 2010
    BigBoyVn, Sep 3, 2010
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Amplifier IR control

  2. Tinny sound from amplifier

  3. MRA Amplifier & Local Input Only

  4. Limit Volume of C-Bus Amplifier

  5. 560110R Amplifier specs

  6. Bridging 560125R Remote Amplifier?

  7. NEO, multiple timers on multiple keys, same group

  8. Power ON Multi room audio remote amplifier after power reset?

Loading...