Multisensor identifying

Discussion in 'C-Bus Wired Hardware' started by fatso, Jun 23, 2020.

  1. fatso

    fatso

    Joined:
    Jul 10, 2017
    Messages:
    16
    Likes Received:
    0
    Location:
    Midlands
    I was wondering if anyone knew of an easy way to id sensors, I have quite a few commercial commissioning jobs and the electricians install the sensors quite high up, they keep the serial numbers but they often get mixed up and becomes a nightmare. Can you make the led flash or something like that? Cheers
     
    fatso, Jun 23, 2020
    #1
  2. fatso

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,554
    Likes Received:
    180
    Location:
    Adelaide, Australia
    Using toolkit you can have the led ON, OFF or flashing on movement. So you could start by turning all the leds off then turning them on or flashing one at a time to locate each sensor.
     
    Ashley, Jun 24, 2020
    #2
    fatso and N.W.B like this.
  3. fatso

    fatso

    Joined:
    Jul 10, 2017
    Messages:
    16
    Likes Received:
    0
    Location:
    Midlands
    Hi Ashley, had a look at toolkit and turns out there is no option for changing the led (or i cant find it) on the 5754ODPEIR - senpilla, i remember seeing on other sensors, cheers
     
    fatso, Jun 25, 2020
    #3
  4. fatso

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,554
    Likes Received:
    180
    Location:
    Adelaide, Australia
    In the 5754ODPEIR you can disable the led in the blocks tab.
     
    Ashley, Jun 25, 2020
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Multisensor/PIR

  2. Multisensor

  3. Multisensor Light Level

  4. Multisensor

  5. SENPILL (Multisensor) Occupancy sensor enabled after power failure

  6. 06-034-1 Remote Triggering Of Scenes A Using MultiSensor

  7. Identifying Staff

  8. Identifying the last unit to Change a GA

Loading...