Output Logic switching

Hi All
What I am trying to work out is how to use one switch to turn on & off 2 different group addresses say Study 1 Lts and Study 2 Lts.
I have set this up in the Relay output of the logic using (or).

I would also like to have on a different switch 2 gang one switch to turn on & off Study 1 Lts and the other turn on & off study 2 Lts.
I have managed to work out the above but my problem is if I turn the lights on using the one switch that turns both study lights on I am unable to turn off lights using the 2 gang switch.



Thanks in advance

inpowers

 

Use the blocks tab in the 1G switch to control both group addresses.. Remove logic assignment in the relay unit..

 

Thanks Roosta

Spot on

Regrards inpower

 

Hi Roosta

I jumped the gun.
I did manage to do it on a 2 gang switch on key 1 & key 2,
But how do you get two group address onto the one key with out using the relay logic?

inpowers

 

As mentioned, its done in the blocks tab of the switch gui.. A 1gang switch can control up to 4 groups.. In the blocks tab choose your 2 groups and then tick the tick boxes at the end..

 

Hi Roosta

I worked it out had to use the Virtual keys to get it to work.

Thanks

inpowers