PAC as a LonWorks interface?

Discussion in 'C-Bus Wired Hardware' started by nickrusanov, Jun 26, 2005.

  1. nickrusanov

    nickrusanov

    Joined:
    Aug 5, 2004
    Messages:
    308
    Likes Received:
    0
    Location:
    russia
    Could I ask people, having experience, if PAC may be used as LonWorks interface for C-Bus? Issuing RS232 commands from C-Bus group addresses and sending C-Bus group addresses from RS232 custom signals?

    This would be the bomb! :eek:
     
    nickrusanov, Jun 26, 2005
    #1
  2. nickrusanov

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    If you had a LonWorks to RS232 interface, then you could probably use this with a PAC to do a C-Bus to LonWorks interface.

    Protocol conversions can be VERY tricky. I would recommend consulting with the C-Bus Enabled Program coordinator for guidance.
     
    Darren, Jun 27, 2005
    #2
  3. nickrusanov

    nickrusanov

    Joined:
    Aug 5, 2004
    Messages:
    308
    Likes Received:
    0
    Location:
    russia
    Thank you, answer was "partly yes", which is good if you ask my opinion=)
     
    nickrusanov, Jul 1, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Interfacing through P.C. Interface questions

  2. CBus Telephone InterFace

  3. Do I need a C-Bus PC interface aswell when using HomeMinder

  4. IR Elan interface

  5. RTI to PAC Interface via serial

  6. Link to Example : RTI to PAC Interface via serial

  7. using a PAC as a PC Interface

  8. Interface to PAC

Loading...