Phantom CBUS acivation

Discussion in 'General Discussion' started by theboyg, Jan 21, 2007.

Page 2 of 2
  1. theboyg

    Phil.H

    Joined:
    Jul 29, 2004
    Messages:
    466
    Likes Received:
    0
    Location:
    Sydney
    So Ashleigh are you referring to 3 x MMI periods ?
     
    Phil.H, Jan 31, 2007
    #21
  2. theboyg

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,397
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    Yes, with the typical interval of 3 seconds. So the interval between a discrepancy and a fixup is normally about the 10 second mark.
     
    ashleigh, Jan 31, 2007
    #22
  3. theboyg

    Hunter

    Joined:
    Jan 30, 2007
    Messages:
    4
    Likes Received:
    0
    Thanks everyone for your suggestions.

    Jasons solution was where I was heading.
    Rather than setting a master all off schedule, a scene schedule with all relevant individual groups ramped off sounds like my answer.

    I will run a diagnostic and event log prior just to confirm.

    Thanks again.
     
    Hunter, Feb 1, 2007
    #23
Page 2 of 2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. CBus v3 Software ?!

  2. CBus Telephone InterFace

  3. Phantom groups question

  4. Phantom groups through C-gate

  5. Phantom Group status

  6. AMX and cbus use together,can cbus feeback to AMX?

  7. PAC store phantom groups?

  8. new to cbus- help chabnging cbus clock on PAC- 12 hrs outof sync

Loading...