pir enable/disable

Discussion in 'C-Bus Toolkit and C-Gate Software' started by MarkWES, May 9, 2013.

  1. MarkWES

    MarkWES

    Joined:
    Jan 28, 2013
    Messages:
    3
    Likes Received:
    0
    Location:
    Perth
    Hi Guys. Does a group address used to disable a pir only have to be above 0% to disable, or does it have to be at 100%? I am trying to disable a pir so someone can leave the room without retriggering pir, after turning the lights off at a local switch. I was hoping to be able to ramp off the group address over a certain time.

    Thanks again.
     
    MarkWES, May 9, 2013
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 06-019-1 Enable & Disable Status After A Power Failure

  2. Outdoor PIR Enable/Disable

  3. PIR enable/disable from PAC

  4. Sensor Enable Disable

  5. PIR Sensor Enable/Disable

  6. Using scenes to enable/disable sensors

  7. Enable PIR with light level from another PIR

  8. Disable PIR and switch with scene, then enable again with all off

Loading...