Power supply for initial programinng

Discussion in 'C-Bus Wired Hardware' started by Grahamiwa, Oct 20, 2011.

  1. Grahamiwa

    Grahamiwa

    Joined:
    Feb 18, 2007
    Messages:
    16
    Likes Received:
    0
    Location:
    Philippines
    In the C-Bus training material it says to connect a PC interface and a C-Bus power supply, and then connect each unit to do the initial planning.

    I have 3 relays which will be supplying the power to my C-Bus. Can I easily use one of these for the power supply for the programming of my other C-Bus units?
     
    Grahamiwa, Oct 20, 2011
    #1
  2. Grahamiwa

    SBL

    Joined:
    Nov 11, 2009
    Messages:
    48
    Likes Received:
    0
    Location:
    NZ
    Yes you can
     
    SBL, Oct 20, 2011
    #2
  3. Grahamiwa

    Ashley W

    Joined:
    Aug 4, 2004
    Messages:
    304
    Likes Received:
    3
    Location:
    Canberra
    Provided those relays have in-built power supplies. Not all do.
     
    Ashley W, Oct 24, 2011
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Toolkit - Initial Network Setup

  2. Ceiling Sweep Fans and Low Power Supply

  3. Power Supply 5100PS not recoginzed in Toolkit

  4. C-Bus Module ver.3.15 - how I can receive initial levels of groups?

  5. Initial Setup of 5000SM/2 module

  6. 5000ctc- searching for power supply

  7. Power Supply board for 8ch DIN relay unit

  8. Not Detecting on your IP Network - Initial Install

Loading...