Problem reading from General Input 0-1Volt range

Discussion in 'C-Bus Wired Hardware' started by [email protected], Feb 13, 2006.

  1. pharvey@leighmaree.com

    [email protected]

    Joined:
    Sep 4, 2005
    Messages:
    11
    Likes Received:
    0
    Hi,

    Have a signal that is output around 0.5 volts. I am trying to read voltage using 0-1 volt range on General Input module. It reads fine when in the 0-5 volt range but just returns "0" in the desired 0-1 volt range...

    Any ideas as to why this is not working ?:confused:
     
    [email protected], Feb 13, 2006
    #1
  2. pharvey@leighmaree.com

    CC&C

    Joined:
    Aug 17, 2004
    Messages:
    86
    Likes Received:
    0
    I experienced the same problem, refer (2nd page into thread):

    http://www.cbusforums.com/forums/showthread.php?t=807

    In the end had to send the unit back for replacement.

    (P.S. I only just received the unit back and haven't had a chance to see if the new unit works yet.)

    Regards, cc&c.
     
    CC&C, Feb 16, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. General Input Unit

  2. General Key input questions

  3. Do you use PC_GIM (General Input Unit)?

  4. General Input Module

  5. General Input Unit 5504GI

  6. 06-016-1 Testing the General Input's Channels

  7. General Input/Auxiliary Input and 240Vac

Loading...