Scene toggle on DLT

I'm trying to work out a way of toggling a scene on a DLT with one button.
Any ideas???

Thanks

 

Another question
Is there a way of setting the turn on light level?
i.e. Want the boy's bedroom light so wen first turned on only goes to 30% then dim up/down from that point.

Thanks

 

For Scene Toggling from 1 button, this has been discussed several times on the forum. The search function is your friend:
http://www.cbusforums.com/forums/showthread.php?t=1087&highlight=Scene+Toggle
http://www.cbusforums.com/forums/showthread.php?t=4674&highlight=Scene+Toggle
http://www.cbusforums.com/forums/showthread.php?t=4578&highlight=Scene+Toggle
http://www.cbusforums.com/forums/showthread.php?t=4414&highlight=Scene+Toggle
http://www.cbusforums.com/forums/showthread.php?t=3597&highlight=Scene+Toggle
http://www.cbusforums.com/forums/showthread.php?t=2072&highlight=Scene+Toggle

To make the light turn on at 30% on first press, go to the Key Functions tab of the key unit you're programming and change the Short Release function on that key to Memory Toggle 2. Then go to the Blocks tab and change the Recall 2 value from 100% to 30% for the corresponding Group Address.

 

Thanks Newman

I trawled thru the older posts before posting the question but will have another crack it tomorrow.
As for the 30% first I tried a whole heap of different things but obviously not recall 2 ( think I used recall 1)
Don't yet understand how all the key functions work as wasn't covered at all in the basics course. Hence the questions and home install.

Thanks again
Derek

 

Alright I can get it to start at 30% and dim up/down but is just acting like a normal memory dimmer.

Currently have it as

Short press-idle
Short release- Memory toggle 2
Long press- Downcycle
Long Release- End ramp

Recall 2 - 30%

Function - Dimmer