SENPILL - Store & 1 2 stuck on 16%

Discussion in 'C-Bus Wired Hardware' started by gsnibson, Dec 9, 2004.

  1. gsnibson

    gsnibson

    Joined:
    Sep 22, 2004
    Messages:
    4
    Likes Received:
    0
    I am trying to use the RECALL1 command on a SENPILL Firmware 1.9.00 and cannot seem to set the store % 1 or 2 to anyother value than 16%. The GUI TIMERS page allows me to set the value to anything on the pull down list and save it to the network etc. However when I open the SENPILL device backup again the values have all gone back to 16%

    Am I missing something???

    Thanks for your help in anticipation
     
    gsnibson, Dec 9, 2004
    #1
  2. gsnibson

    Duncan

    Joined:
    Jul 23, 2004
    Messages:
    925
    Likes Received:
    0
    Location:
    Salinas de Garci Mendoza, Bolivia

    Hi,

    Can you advise what version of either Toolkit or the V2 software you are using?
     
    Duncan, Dec 9, 2004
    #2
  3. gsnibson

    gsnibson

    Joined:
    Sep 22, 2004
    Messages:
    4
    Likes Received:
    0
    Duncan,
    I tried both the V2.7.9 and the V2.7.7 of the installation software. Both were the same. I then tried a SENPIRSS unit and I could set that fine.

    I have 5 SENPILL units and the all exhibit the same issue.
     
    gsnibson, Dec 10, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Piced store scene

  2. Download to Nirt gets stuck

  3. Restarting stuck Transmitter

  4. Old C-Touch stuck while download project

  5. C-Touch Colour Problems - Stuck at Startup Screen

  6. Single Zone Thermostat Circulation Relay Stuck ON

  7. Ctouch firmware update stuck

  8. Stuck on 'Hang on we're getting all your controls ready"

Loading...