Serial Baud Setting Failed

Discussion in 'C-Bus Toolkit and C-Gate Software' started by MHeaton, May 21, 2008.

  1. MHeaton

    MHeaton

    Joined:
    Apr 22, 2008
    Messages:
    106
    Likes Received:
    2
    Location:
    London
    I am running CGate on a relatively old PC (version 1.8.3 of toollkit). I am connecting to a CBUS network via the PAC and, first time round it all worked fine. Add New Hardware Wizard detected the COM port as COM3, installed the driver and I was able to connect.

    One reboot later it reinstalled on COM4 and since then I have been unable to connect. I should point out that COM1 and COM2 are disabled in the BIOS as I ran out of interrupts..


    Any one any ideas?

    Thanks
    Mark
     
    MHeaton, May 21, 2008
    #1
  2. MHeaton

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    The title of your post was "serial baud setting failed". You haven't explained the significance of the baud rate. Is this related to the problem ?
     
    Darren, May 22, 2008
    #2
  3. MHeaton

    MHeaton

    Joined:
    Apr 22, 2008
    Messages:
    106
    Likes Received:
    2
    Location:
    London
    All sorted - a restart of the PAC cured whatever the problem was. I think something had gone awry with the USB port.

    Thanks
    Mark
     
    MHeaton, May 23, 2008
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Lantronix UDS10B Com Port Redirector ?Failed to Connect? Error

  2. Hardware key: Key initialize failed (DRIVER NOT INSTALLED)

  3. Network lock failed

  4. Unit Transfer Failed

  5. Failed to read network

  6. Failed to Identify Network

  7. PCI sync failed - normal?

  8. 4 Channel Dimmer failed

Loading...