Thermostat Conrols

Discussion in 'C-Bus Wired Hardware' started by exsolter, Oct 31, 2010.

  1. exsolter

    exsolter

    Joined:
    Feb 5, 2005
    Messages:
    31
    Likes Received:
    0
    Hello

    Is there any in depth guides to programming the thermostat?

    I have a network that wants to control A/C with cbus

    1: Five rooms onto a system that I can only looking at using a serial interface to send commands to control a/c unit. I have the serial commands but not fully understand the programming behind the new units

    2: Two rooms same 1: as above

    3: Two rooms same 1: as above

    4: One room that I can control via Low voltage relays with resistor to switch temps and on/off controls

    5: same as 4

    Can anyone give advise on this?
    Or who do I talk to over this?


    Thanks
    Kev
     
    exsolter, Oct 31, 2010
    #1
  2. exsolter

    ashleigh Moderator

    Joined:
    Aug 4, 2004
    Messages:
    2,400
    Likes Received:
    26
    Location:
    Adelaide, South Australia
    Read the help in Toolkit, its your best starting point.
     
    ashleigh, Oct 31, 2010
    #2
  3. exsolter

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    We aren't entirely sure that we understand your requirements. Are you trying to control C-Bus HVAC from another system using serial commands?
     
    Darren, Nov 1, 2010
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.