Time Scheduling in wiser home control

Hello

Can we do time shedulling through Wiser home Control?If Yes How?Please send me programme process.

I have tried with time sheduling,it works with PC/Laptop connected to C-Bus network but when we disconnect PC/Laptop from C-Bus/wiser network we unable to get time scheduling.

please suggest.

 

Zameer,

Yes, you can have scheduling through Wiser. I did not understand what you meant in the last sentence. Keep in mind that scheduling takes a few minutes after a project transfer to start. Typical debug steps are to check that you have C-Bus connectivity, checking on whether the wiser has internet access (used for NTP time) and checking that the schedule is enabled properly. PICED has very useful help manuals about all of this. Have you read through these?

 

Thanks Jay,

Last Scentence means that :-When we do scheduling in wiser and transfer the project it works ok when our laptop is connected to the network/wiser,However when we disconnect our laptop the scheduling which we have set doesn't happen.

regards

 

Do this simple test to confirm that schedules work in Wiser:
1. Create a very simple Wiser project in PICED with a single Widget controlling a light
2. Add a schedule:
- repeat every 1 minute
- pulse light on for 10 seconds, then off
- no enable group
3. Connect PICED to C-Bus and verify that the Schedule is operating
4. Transfer the project to Wiser
5. Wait for a few minutes for the Wiser scheduler to start
6. If the schedule is not doing anything, open the Wiser user interface from a web browser and see if the widget can control the light