Toggle between two values

Discussion in 'C-Bus Wired Hardware' started by znelbok, Oct 21, 2016.

  1. znelbok

    znelbok

    Joined:
    Aug 3, 2004
    Messages:
    1,151
    Likes Received:
    17
    I want to setup a key input to toggle between two values X & Y

    a short press to set it to what ever it is not currently (i.e. if it is X now then a press sets it to Y and if it is Y it sets it to X).

    Can this be done without a logic engine?

    I think I can do it with a short press and long press (idle, recall 1, idle recall 2) but would prefer not to slow the action down with a long press.

    Mick
     
    znelbok, Oct 21, 2016
    #1
  2. znelbok

    Ashley

    Joined:
    Dec 1, 2005
    Messages:
    1,548
    Likes Received:
    178
    Location:
    Adelaide, Australia
    I think we have all tried to do this at some time in the past but I just can't see how it's possible with the existing functions. I always thought that the toggle option should have been a check box that toggles between any selected function and off. I generally just put up with the short and long press options, but if you really want a short press I think you are stuck with the logic solution.
     
    Ashley, Oct 21, 2016
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Toggle, retrig, toggle, idle

  2. SENPILL Pot Values Gone in Status display

  3. interlock values

  4. Calculating network items & values

  5. Comparing Time Values

  6. comparing time values

  7. What is the differences between these two DLT models??

  8. How to toggle Two Relay channels

Loading...