Too much delay to respond- behaviour of the C-Bus network.

Discussion in 'General Discussion' started by Ramesh Babu, Jul 3, 2012.

  1. Ramesh Babu

    Ramesh Babu

    Joined:
    Dec 19, 2011
    Messages:
    11
    Likes Received:
    0
    Location:
    India
    Dear All,


    I am a facing an issue in C-Bus network.

    I have the 8 output devices(L5512RVF,L5504AMP,) and 3 neo switches at 250 mtrs cable length.


    Issue is If I switch on the button on any key pad in the network its taking minimum 5 to 10 sec to respond. either it may single group or scene.

    Please suggest me the solution for this



    Regards
     
    Ramesh Babu, Jul 3, 2012
    #1
  2. Ramesh Babu

    tobex

    Joined:
    Nov 3, 2006
    Messages:
    728
    Likes Received:
    0
    Location:
    Sydney, Australia
    Did you measure the fault with the Clipsal CBUS Tool ?

    I would be checking
    - Clock settings
    - Burden Settings
     
    tobex, Jul 4, 2012
    #2
  3. Ramesh Babu

    Ramesh Babu

    Joined:
    Dec 19, 2011
    Messages:
    11
    Likes Received:
    0
    Location:
    India
    Thanks Tobex...

    Yes I checked ...software burden enabled...and only 2 clocks are enabled in relays
    I unable to find out the root cause.

    Thanks
     
    Ramesh Babu, Jul 4, 2012
    #3
  4. Ramesh Babu

    tobex

    Joined:
    Nov 3, 2006
    Messages:
    728
    Likes Received:
    0
    Location:
    Sydney, Australia
    Remove software burden and install physical burden.
     
    tobex, Jul 4, 2012
    #4
  5. Ramesh Babu

    Newman

    Joined:
    Aug 3, 2004
    Messages:
    2,203
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    You have a network communication issue with your network. I suggest you use the C-Bus Diagnostic utility (free download) to take a look at your network to see if you are experiencing communication errors on your network.
     
    Newman, Jul 6, 2012
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Too many long constants - What The !!!

  2. PAC "Too much logic" - so close!!!

  3. Anyways to delay the retriggering of a PIR?

  4. Does too little voltage (temporarily) cause damage to C-Bus components?

  5. Much work for C bus programmers?

  6. Shutting down wiser with too much/bad logic??

  7. Leading Edge dimmers ! Apparently I complain too much

  8. 5031NIR Inter-key Delay and Inter-Device Delay

Loading...