Toolkit 1.4.1

Discussion in 'C-Bus Toolkit and C-Gate Software' started by Dave Byron, Aug 11, 2006.

  1. Dave Byron

    Dave Byron

    Joined:
    Aug 3, 2004
    Messages:
    835
    Likes Received:
    0
    Location:
    Casurina
    Toolkit 1.4.1
    Toolkit still reports groups as being in use in output when they are not selected as being used in the logic ? thought this was fixed

    dave
     

    Attached Files:

    Dave Byron, Aug 11, 2006
    #1
  2. Dave Byron

    Richo

    Joined:
    Jul 26, 2004
    Messages:
    1,257
    Likes Received:
    0
    Location:
    Adelaide
    This could be based on the behaviour of the hardware. When Toolkit does a check of used groups in a unit the units report the groups assigned to it. This is irrespective of how the groups are be used/not used in the unit. This partially because the unit will be tracking state and contributing MMI information related to those groups even if you have not assigned a purpose to the groups yet.

    If you don't want the group to show as being used you will need to set the group to <unused>.
     
    Richo, Aug 11, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.