Using default Scene ramp rate

Discussion in 'C-Touch/HomeGate/SchedulePlus/PICED Software' started by Josh, Oct 12, 2005.

  1. Josh

    Josh

    Joined:
    Aug 25, 2004
    Messages:
    241
    Likes Received:
    0
    Location:
    Pretoria, South Africa
    I have a a few Scenes that have few GA each with its own ramp rate and levels. I have a few conditions at which the PAC logic changes the levels of these scenes (using SetSceneLevel). It would be nice if I could change the the level using the default ramp rate per GA and not be forced to specify a global ramp rate.

    Is this possible?

    If not, would CIS consider adding this in the NICE TO HAVE LIST?
     
    Josh, Oct 12, 2005
    #1
  2. Josh

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    The bad news : It is not currently possible.

    The good news : It is now on "the list".

    More bad news : the list has now over 1300 items on it, so it may take a while to get to this one :(
     
    Darren, Oct 17, 2005
    #2
  3. Josh

    Josh

    Joined:
    Aug 25, 2004
    Messages:
    241
    Likes Received:
    0
    Location:
    Pretoria, South Africa
    Thanks Darren,

    Just knowing that it will be possible soon is good news. ;)
     
    Josh, Oct 17, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. C-Bus Message Rate

  2. Ramp time with Ramp to Level command

  3. Scan rate of PAC and C-Bus

  4. High error rate using traffic analyser

  5. Max. ramp rate

  6. C-bus MMI Report Rate

  7. PulseCBusLevel Dual Ramp Rate Request

  8. scene cycle & Ramp

Loading...