Where to start

hi my name is daniel
i am new to this stuff and the forum
but am pretty sure this is the type of career i would like to get into
i am currently enrolled in a electrical principles course then next my open cableing
then have been told t get c-bus or other automation courses under my belt
as i have no experience in this area
i would like to know where i should start
and is there information for begginers on this forum ?
thanks in advance

daniel d

 

C-Bus Training

I've attached an intro to C-Bus guide from the basic C-Bus manual. This will give you a decent understanding of what C-Bus is and what it's about.

If you want some C-Bus training the first place to go would be here:

http://www2.clipsal.com/cis/technical/technical_support/training/cbus_control_and_management

You can also look at all of the training manuals here:

http://www2.clipsal.com/cis/technical/technical_support/training2/cbus_control_and_management_system

Hope that helps a bit

Cramer

 

thankyou for your response
i will read on and be back later lol

daniel d

 

do you need to be an electrician to fit this
iam doing all the steps to get my austel ticket at the moment
but someone told me today that you may need to be an electrician to fit it ??

daniel d

 

Hi Daniel

In Australia you are required to hold an electrical licence to carry out any mains rated (240 volt) work.

You do not need an electrical licence for programming C-Bus.