Wiser CNI pci firmware

Discussion in 'C-Bus Wiser 1 Controller' started by Newbie, Aug 6, 2012.

  1. Newbie

    Newbie

    Joined:
    Jun 16, 2010
    Messages:
    45
    Likes Received:
    0
    Location:
    South Africa
    Ok, I cant control lights via wiser I can scan the CNI etc and open the LAN GUI but I have a no C-Bus symbol in the top right hand corner of the screen.

    When I scan the CNI using IP utility the serial number comes up as "No Serial #" and the PCI firmware shows 0.0.00 instead of 5.4.00

    How do I change the CNI PCI firmware version to 5.4.00?
     
    Newbie, Aug 6, 2012
    #1
  2. Newbie

    NickD Moderator

    Joined:
    Nov 1, 2004
    Messages:
    1,427
    Likes Received:
    64
    Location:
    Adelaide
    Sounds like the C-Bus side of the CNI is not responding... I assume it is connected to the C-Bus network? Are the LEDs on the CNI on? If so, what colours are they?

    Nick
     
    NickD, Aug 7, 2012
    #2
  3. Newbie

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    It sounds like you may have a faulty CNI.

    It is not possible.

    When you scan the network from ToolKit (using a different PCI or CNI), does the Wiser CNI show up with a serial number?
     
    Darren, Aug 7, 2012
    #3
  4. Newbie

    Newbie

    Joined:
    Jun 16, 2010
    Messages:
    45
    Likes Received:
    0
    Location:
    South Africa
    Hi Darren, when I scan the network with another interface the CNI shows up but it does not have a serial number?

    Hi Nick, the CNI is connected to C-Bus, the CNI LED's are on but the C-Bus LED if flashing red and green rapidly?

    :confused:
     
    Newbie, Aug 7, 2012
    #4
  5. Newbie

    Darren Senior Member

    Joined:
    Jul 29, 2004
    Messages:
    2,361
    Likes Received:
    0
    Location:
    Adelaide, South Australia
    Sorry to be a grammar Nazi, but is this a statement or a question?

    If it has no serial number when scanned from ToolKit, the unit is most probably faulty.
     
    Darren, Aug 8, 2012
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. PCI, CNI, Lantronics redirection and the Public Release Protocol

  2. Remote network, CNI and PCI

  3. Pci To Cni

  4. Different Version/Firmware of PCI

  5. PCI Firmware.

  6. CNI and PCI Serial Interface

  7. CNI 5500 module vs Wiser CNI

  8. Ethernet PCI Interface firmware

Loading...